Discovery 4 3.0 TDV6 SDV6 Engine Supply & Fitting fitted WITH WARRANTY

Genuine Used TESTED LOW MILEAGE. 3.0 TDV6 & SDV6 Engine. Quality service we provide to our customers.

In addition to our normal servicing and maintenance operations, we are specialist engine builders. V6 engine is prone to failures if not maintained properly. We've seen many types of failures such as. 1/Hole in the block 2/Timing belt tensioner displacement 3/Snapped crank 4/Worn bearings.

Each engine is stripped down and inspected BEFORE replaced to used or remanufactured. Any questions let as know- --Recovery collection also available at extra cost if not local. The cylinder heads are chemically cleaned to remove any carbon deposits, then skimmed, crack&pressure tested.

The valve seats are recut and lapped, then new stem seals fitted. The camshaft followers are cleaned & inspected or. The camshafts are cleaned/inspected and measured. The engine block is deep cleaned, measured and honed or rebored as required. The crankshaft is either polished or reground to a new specification.

The crankshaft is balanced along with the conrods, pistons, flywheel and front pully. The pistons are cleaned and measured. As well as the normal checking, machining and cleaning, each of our reconditioned engines includes the following NEW items.

Full top and bottom OEM gasket set. Hydraulic lifters Oil Pump Full timing belts & tensioners Water Pump Timing chains, guides & tensioners Main bearing Big end bearings Oil Filter x2 Front & Rear oil seals. Our best practice service also includes. Recovery and recharge of A/C gas. Complete change of brake fluid. Gearbox & Diff oil levels checked. EGR valves are cleaned & inspected. As is normal with any reconditioning service, any MAJOR parts that can not be used such as crankshaft or engine block are subject to a replacement surcharge. Once the engine is fitted, we connect our bespoke diagnostic test equipment to monitor the oil pressure in 3 different places, the crankcase pressure and oil temperature. We then run it up to operating temperature, check the correct oil pressure is produced and check for any problems. After the initial start up phase, we then carryout the first part of a 100 mile road test. This first test is to ensure that all the systems are working correctly and the car is safe to drive. After the first test, the car is back in to the workshop to recheck the engine.

Once this inspection has passed, we then take the car for a 80 mile road test, recording all the parameters of the engine performance. After this test drive, we once again inspect the engine and carryout a cylinder pressure test to ensure that the piston rings are bedding in correctly. If all is correct, we then carryout some stop/start journeys to ensure normal driving conditions are met. Only after all tests have been carried out and passed, we then drop the oil out to inspect it and replace it with fresh oil and a new filter. We then stamp your service book for oil & timing belt replacement.

WILL THIS ITEM FITS TO YOUR VEHICLE? To ensure you order the correct part for your car's particular make and model, please pay careful attention to the item specifics and description. The goods you order, will be delivered to the address you give when you place your order unless agreed in writing.

Upon receipt of a damaged item we will require evidence by photographs and also photos of all the packaging as the courier will not process any claim without. IF YOU RECENTLY BEEN CHANGED YOUR ADDRESS AND IT'S NOT BEEN CHANGED IN YOUR ACCOUNT, PLEASE LET US KNOW BEFORE WE POST ITEM. We will ALWAYS try our best to help. This item is in the category "Vehicle Parts & Accessories\Car Parts & Accessories\Engines & Engine Parts\Engines". The seller is "part-for-you" and is located in this country: GB.

This item can be shipped to United Kingdom.

Manufacturer Part Number: 306DT
Number of Cylinders: 6
Reference OE/OEM Number: 306DT
Engine Size: 3.0L
Fuel Type: Diesel
Brand: LAND ROVER (Genuine OE)
Block Type: Inline